Pole Installation Instructions
|
|
Raising the Dori Pole on a Temporary Stake
- Stake should be driven deep enough so the 90 metal plate
touches ground. In soft ground or at public events, the top
of the plate should be flush with the ground for safety.
- When raising the pole, place the pole at the base of the stake-
then WALK the pole UP until it's vertical. Grab the pole
approximately 2' above the ground with the other hand 2'
above that. Lift the pole straight up and over the stake.
|
Note: Attempting to raise the pole by pivoting the pole over the
end of the stake is not the recommended method and may void the warranty.
Ground Mounting
for a Permanent Installation.
- The hole should be 6" to 8" dia. x 20" deep. After digging
hole- place 2" of drainage gravel at bottom. Set the 1.5" x 18"
(sched.80) PVC tube w/ nail-stop positioned 1/2" from bottom.
Sleeve should protrude 1/2" above ground surface. Backfill with
RediMix post hole concrete- sloping downward for drainage.
- When security is required, drill through the sleeve and pole
with a 1" long non-corrosive screw, (not included).
|
![[graphic element]](../nav/transition.gif){kind=small}
![[graphic element]](../nav/cdg_lffill.gif){kind=small}
![[graphic element]](../nav/cdg_rtfill.gif){kind=small}
![[graphic element]](../nav/terminus.gif){kind=small}
